See
http://www.cs.tut.fi/~leopold/Ld/VideoFormats.html. Basically it has 100 more scan lines, runs at 25fps, and I think it samples color/lumina differently. I think it runs at 4:2:0 and NTSC is 4:1:1 but I might be wrong.
From
http://www.ee.surrey.ac.uk/Contrib/W.../compare.html:
begin quote
NTSC/525 Advantages
· Higher Frame Rate - Use of 30 frames per second (really 29.97) reduces visible flicker.
· Atomic Colour Edits - With NTSC it is possible to edit at any 4 field boundary point without disturbing the colour signal.
· Less inherent picture noise - Almost all pieces of video equipment achieve better signal to noise characteristics in their NTSC/525 form than in their PAL/625.
NTSC/525 Disadvantages
· Lower Number of Scan Lines - Reduced clarity on large screen TVs, line structure more visible.
· Smaller Luminance Signal Bandwidth - Due to the placing of the colour sub-carrier at 3.58MHz, picture defects such as moire, cross-colour, and dot interference become more pronounced. This is because of the greater likelihood of interaction with the monochrome picture signal at the lower sub-carrier frequency.
· Susceptablity to Hue Fluctuation - Variations in the colour subcarrier phase cause shifts in the displayed colour, requiring that the TV receivers be equiped with a Hue adjustment to compensate.
· Lower Gamma Ratio - The gamma value for NTSC/525 is set at 2.2 as opposed to the slightly higher 2.8 defined for PAL/625. This means that PAL/625 can produce pictures of greater contrast.
· Undesirable Automatic Features - Many NTSC TV receivers feature an Auto-Tint circuit to make hue fluctuations less visible to uncritical viewers. This circuit changes all colours approximating to flesh tone into a "standard" fleshtone, thus hiding the effects of hue fluctuation. This does mean however that a certain range of colour shades cannot be displayed correctly by these sets. Up-market models often have this (mis)feature switchable, cheaper sets do not.
PAL/625 Advantages
· Greater Number of Scan Lines - more picture detail.
· Wider Luminance Signal Bandwidth - The placing of the colour Sub-Carrier at 4.43MHz allows a larger bandwidth of monochrome information to be reproduced than with NTSC/525.
· Stable Hues - Due to reversal of sub-carrier phase on alternate lines, any phase error will be corrected by an equal and oposite error on the next line, correcting the original error. In early PAL implementations it was left to the low resolution of the human eye's colour abilities to provide the averaging effect; it is now done with a delay line.
· Higher Gamma Ratio - The gamma value for PAL/625 is set at 2.8 as opposed to the lower 2.2 figure of NTSC/525. This permits a higher level of contrast than on NTSC/525 signals. This is particularly noticable when using multi-standard equipment as the contrast and brightness settings need to be changed to give a similar look to signals of the two formats.
PAL/625 Disadvantages
· More Flicker - Due to the lower frame rate, flicker is more noticable on PAL/625 transmissions; particularly so for people used to viewing NTSC/525 signals.
· Lower Signal to Noise Ratio - The higher bandwidth requirements cause PAL/625 equipment to have slightly worse signal to noise performance than it's equivalent NTSC/525 version.
· Loss of Colour Editing Accuracy - Due to the alternation of the phase of the colour signal, the phase and the colour signal only reach a common point once every 8 fields/4 frames. This means that edits can only be performed to an accuracy of +/- 4 frames (8 fields).
· Variable Colour Saturation - Since PAL achieves accurate colour through cancelling out phase differences between the two signals, the act of cancelling out errors can reduce the colour saturation while holding the hue stable. Fortunately, the human eye is far less sensitive to saturation variations than to hue variations, so this is very much the lesser of two evils.
End quote.
Linear Mode
